• 
• 
• 

Телеметрия посредством Canopy

Спецификация на оборудването

Canopy Access Point Module 2400AP/5400AP
	Operating Frequency Range U-NII Mid band	2.4 to 2.483.5 GHz and 5.470 to 5.725 GHz
	Access Method	TDD/TDMA
	Signaling Rate	10 Mbps (20 Mbps - Advantage)
	Modulation Type	High Index BFSK (Optimized for interference rejection)
	Carrier to Interference (C/I)	3dB 10-4 BER @ -65 dBm
	Receiver Sensitivity	-83dBm 10-4 BER
	Operating Range	Up to 3.2 km. with integrated antenna in the 5.4 GHz band. Up to 10 km. with passive reflector in the 5.4 GHz band on SM module.
	Transmitter Power	Meets FCC UNII ERP Limit
	DC Power	24 VDC @ 0.3 Amp (active state)
	Interface	10/100 BaseT, half/full duplex Rate auto negotiated (802.3 compliant)
Canopy AP – Точка за Достъп се използва в качеството на ретранслатор за доставяне но Интернет услуги на абонатите. Един Canopy AP клъстър може да съдържа до 6 АР Точки за достъп, захранващ модул, GPS приемник за синхронизация, Ethernet комутатор. На една Точка за Достъп АР могат да бъдат регистрирани до 200 Абонатстки модула SM. Един АР може да адресира до 4096 MAC / Ethernet адреса.	Protocols Used by CANOPY	IPV4, UDP, TCP, ICMP, Telnet, HTTP, FTP, SNMP
	Software Upgrade Path	Remotely downloaded into FLASH via RF link
	Network Management	HTTP, TELNET, FTP, SNMP
	Wind survive	190 km/hr (118 miles/hr)
	Operating Temperature	-30ЕC to +55ЕC (-40ЕF - +131ЕF)
	Weight	1 lb. (.45kg)
	Dimensions	11.75" H x 3.4" W x 3.4" D (29.9 cm H x 8.6 cm W x 8.6 cm D)
Canopy Cluster Management Module 1008CK
	Max length any one adio can be from Cluster Management Module	100 Meters
	Dimensions	11.75” H x 15.0” W x 6.25” D (29.9 cm H x 38.1 cm W x 41.3 cm D)
	Weight	19.0 lbs. (8.6 kg)
	Operating Temperature	-30ЕC - +55ЕC (-40ЕF - +131ЕF)
	AC input voltage	90 VAC to 260 VAC
	AC frequency	47 to 63 Hz
	AC input power	75 W Typical with 8 radios, 90 W max at 120 VRMS
Модулът за управление на АР клъстера осигурява комутацията на отделните АР по време, тяхното захранване от мрежата и тяхната синхронизация.	AC inrush current	25A at 115 VAC 50A at 240 VAC
	current (cold start –40C)	50A at 240 VAC
	EMI emissions	FCC part 15, class A
24 VDC Power Supply
	24 VDC @ 12A	Radios 100 Meters maximum from Cluster Management Module
12 VDC Power Supply
	Radios 20 feet maximum from Cluster Management Module (8 radios), Power supply can be 10 feet from Cluster Management Module with Min. 12 gauge copper wire.	5.68A typical
Grounding
	Cluster Management Module	Must use 10 gauge copper wire to attach one end to the chassis plate in the Cluster Management and the other end to earth ground, per National Electrical Code (NEC).
Cable Specifications
	Ethernet, GPS sync, and GPS coax cables	The use of cables that conform to the operational temperature of the product as well as being UV light protected is mandatory
GPS
	“Keep Alive” battery power	Upon power up, Cluster Management needs 5-minutes to recover GPS timing pulse. It is strongly recommended to have an uninterrupted power supply (UPS) back up on the Cluster Management Module power system.
Ethernet Switch
	Switch type	Unmanaged, store & forward
	Ethernet protocols supported	All standard IEEE 802.3
	Full or half duplex operation	Auto-sensing
Canopy Subscriber Module 2400SM/5400SM
	Operating Frequency Range U-NII Mid band	2.4 to 2.483.5 GHz and 5.470 to 5.725 GHz
	Access Method	TDD/TDMA
	Signaling Rate	10 Mbps (20 Mbps - Advantage)
	Modulation Type	High Index BFSK (Optimized for interference rejection)
	Carrier to Interference (C/I) - also known as Jitter	3dB, 10-4 BER @ -65 dBm
	Receiver Sensitivity	-83dBm 10-4 BER
	Operating Range (all weather)	Up to 3.2 km with integrated antenna in the 5.4 GHz band. Up to 10 km with passive reflector in the 5.4 GHz band.
	Transmitter Power	Meets FCC UNII ERP Limit
	DC Power	24 VDC @ 0.3 Amp (active state)
	Interface	10/100 BaseT, half/full duplex Rate auto negotiated (802.3 compliant)
Всеки един абонатски модул Canopy SM може да работи само с една Точка за достъп AP в определения времеви слот.Синхронизацията и управлението се извършва по радиоканала от Точката за достъп Canopy SM се монтира на открито и се ориентира към Точката за достъп по линията на пряката видимост.Модула се включва към крайната апаратура посредством специален кабел САТ-5, който има защита от ултра виолетовотото излъчване.	Protocols Used by Canopy	IPV4, UDP, TCP, ICMP, Telnet, HTTP, FTP, SNMP
	Protocols Supported by Canopy	Switched Layer 2 Transport with support for all common Ethernet protocols including IPV6, NetBIOS, DHCP, IPX, etc.
	Software Upgrade Path	Remotely downloaded into FLASH via RF link
	Network Management	HTTP, TELNET, FTP, SNMP
	Wind	190 km/hr (118 miles/hr)
	Operating Temperature	-30ЕC - +55ЕC (-40ЕF - +131ЕF)
	Dimensions	11.75” H x 3.4” W x 3.4” D (29.9 cm H x 8.6 cm W x 8.6 cm D)
	Weight	1 lb. (.45kg)
Canopy Backhaul Module 5400BH
	Operating Frequency Range U-NII Mid band	5.470 to 5.725 GHz
	Access Method	TDD/TDMA
	Signaling Rate	10 Mbits, 20 Mbits, 30 Mbits, 60 Mbits, 150 Mbits and 300 Mbits (Depends on the model.)
	Modulation Type	High Index BFSK (Optimized for interference rejection)
	Carrier to Interference (C/I) - also known as Jitter	3dB, 10-4 BER @ -65 dBm
	Receiver Sensitivity	-83dBm 10-4 BER
BH модул /основен – master режим/ – използва се за организиране на канал за свръзка тип точка до точка, за присъединяване към пакетната мрежа на отделен АР cluster/ група от модули за достъп. BH модулите могат да използват, както остро насочена антена, така и антена с диаграма на излъчване 600. При всяка една конфигурация с използването на ВН единия задължително се установява, като master/основен/ а другия ВН се установява, като подчинен slave. Основния ВН предава синхронизиращите импулси на подчинения. BH се присъединява към групата от АР, като обикновена точка за достъп.	Operating Range (all weather)	Depends on the model.
	Transmitter Power	Meets FCC UNII ERP Limit
	DC Power	24 VDC @ 0.3 Amp (active state)
	Interface	10/100 BaseT, half/full duplex Rate auto negotiated (802.3 compliant)
	Protocols Used by Canopy	IPV4, UDP, TCP, ICMP, Telnet, HTTP, FTP, SNMP
	Protocols Supported by Canopy	Switched Layer 2 Transport with support for all common Ethernet protocols including IPV6, NetBIOS, DHCP, IPX, etc.
	Software Upgrade Path	Remotely downloaded into FLASH via RF link
	Network Management	HTTP, TELNET, FTP, SNMP
	Wind survive	190 km/hr (118 miles/hr)
	Operating Temperature	-30ЕC - +55ЕC (-40ЕF - +131ЕF)
	Dimensions	11.75” H x 3.4” W x 3.4” D (29.9 cm H x 8.6 cm W x 8.6 cm D)
	Weight With Passive Reflector	1 lb. (.45kg) 6.5 lbs. (3 kg)
Canopy Surge Suppressor 300SS
1. Mounting holes 2. RJ-45 connectors 3. Ground post	Dimensions	H 5.2” x W 5.0” x D1.7” H 132 mm x W 127 mm x D 43.2 mm
	Space between mounting holes	4.25” (108 mm)
	Size of Knockouts	0.75” (19 mm)
	Weight	0.4 lbs. (180 g)
	Operating Temperature	-30ЕC to +55ЕC (-40ЕF to 131ЕF)
	Internal Connectors	RJ45
	Capacity	1500J peak pulse energy dissipation with 10/10000µs waveform

^ нагоре